what would i have to do to get the "denali" logos off the side? and if i get them off were there be holes there of will it be smooth?
Printable View
what would i have to do to get the "denali" logos off the side? and if i get them off were there be holes there of will it be smooth?
fishing line and 2 pairs of vice grips and then there wil be no holes, as for the foam tape go to a paint store and get an eraser wheel and it will come right off
do i just run the line in between the emblem and then pull it off with the vise grips?
use the vise grips on each end of the line then pull it tight and run the line between the letter and the body on the truck, it will slice through the foam tape
aaaahhhhh!!!! got it, ill try this later when im not under flood and tornado warnings
lmao yeah that makes it a little easier and that eraser wheel is well worth buying, it just goes in the end of the drill and saves you a lot of heartache, i take these things off when i have to letter trucks and i have tried every known way
im sure the paint/body shop at my race shop will have something i can use. i was looking at my truck the other day and just decided i didnt like the way those logos looked...
+1 on the debadge...will clean up the look alot!!!:thumb:
yeah im not a big badge person, makes it look cleaner without themQuote:
Originally Posted by mitch cobb racing
once you remove the foam tape with the eraser you can use little bit of lacquer thinner to remove the residue left over from the eraser and glue from tape