Printable View
Well, i got my shaft in and it still vibrates, this was the first replacement. I had a bad vibration at 60mph+. I took it back and now i have the other one in. It vibrates at 80mph+. I may pull the tailshaft off the tranny and see if anything is messed up in there. I did inspect it and everything looked ok without pulling it.
see ya,
allen
how many you gonna go through til you go aluminum? or is the one you got aluminum?
Brandon
hahah, i hope this is the last one.
update again:
I went by joe's trans shop (i love that shop) and told him about my problem. He suggested I take an extra trans tailshaft and switch it out with mine. When I got hom, i pulled everything, shaft and tailshaft, and i noticed the brass bushing in the tailshaft was all fcked up. Well kind of, it was very worn and there was a lot of brass particles on my hands after i messed with it. When the shaft originally broke, it must of been violent, it made the reluctor ring slam against the vss sensor and put a good sized scar on it. I'll be replacing the vss also just in case, it still reports the correct speed, but just in case.
later,
allen