I was wondering if the 5.3 heads would bolt up to the 6.0 lq9 block?
Thanks in advance, Tom (4doorvett)
Printable View
I was wondering if the 5.3 heads would bolt up to the 6.0 lq9 block?
Thanks in advance, Tom (4doorvett)
yes they'll bolt up, it will also raise the compression..
they will also not flow nearly as well. If you put them on have them ported. or just grab some 243 heads, they flow the same and are 64.5cc instead of 73 like the 317s
def. have them ported
so well wil some 862's milled 30 ,ported ,3 angle valve job and the 317 valves work on an lq9 good
Quote:
Originally Posted by most-hated
NO! whatever you do DO NOT MILL THEM reason being it would put the compression above 12:1:eek: pending on what you wanna do depends on what you get, are you naming heads cause there cheap or you have them already?
you can find 243s rather cheap, i would mill them and port those..
Just check wit the guy that did the heads there 862 ,rock port , 3angle valve job and milled 5 but the heads git warped 1ns due to over heat and got milled 5 more which is 10 is that good or should my friend change the heads he went 11.4@ 122mph spinng mods are lq9 ms3 cam stall full bolt on wat do u thing should he change the heads
11.4 damn i wouldnt change **** lol add some juice and be happy...
so the 10 milling is not bad ?
I was thinking of upgrading to LQ9 Block, just thinking ahead. Thanks for the input. I do appriciate it!