Sale- 347ci

balanced crank, eagle h beam rods, diamond forged pistons, 9:1 comp., patriot stage 2 heads w/ complete valve job, pistons coated tops and skirts, completely rebuilt since i purchased the long block from Billy at trt. cam 216/224 w/ .510/.510 lift, definitely go bigger on cam., 110 degree lobe seperation angle, needs new intake manifold. reason for selling is i rolled my truck. will also give the tranny and rearend w/ purchase. tranny has 2400-2800 stall, pretty much fully built by Rutland in spring, tx, rearend is 3.73 posi w/ auburn. ASKING $4500.00 you pull it all out. email me @ adamlongbotham @yahoo.com only has around 200 miles since build. i have a sound clip on my myspace page

Attachment 777

Attachment 778

is it a 10 bolt rear end?

yes 10 bolt

how was rutland's work?
i drove past there one day and seen their shop but didn't have any info about them.
i asked on another site if anybody has heard of them or had anything built by them and they all said no.

they built my 454ss th400 tranny and it was bullet proof. the tranny they built for my 03 silverado was great also, when you tell them what its gonna be used for they will know exactly what to do and they back their work up. they are great.
they are big into racing and have race cars. they know what they are doing. i would recommend them to anyone

please read above. anything good on the truck u can have

Everything on the truck w/ engine, tranny, rear end. Make an offer or just bring a flatbed. Asking $5000.00

Will you pull the auburn?

Probably, not sure exactly what part or series it is though. if you live near by you can come take a look someday or later when i am not busy i will take some photos. I cant find the reciept or i would post it.

I believe this is the motor I traded to Billy for my 408ci. The same one that took my 5250lb crew cab 12.9 in the 1/4 on 10 psi boost. Tough motor!!!! It would look good in my camaro if I could steal it. Let me know if you get desparate.