+ Post New Thread
Page 101 of 356 FirstFirst ... 51 91 99 100 101 102 103 111 151 201 ... LastLast
Threads 2001 to 2020 of 7105

Forum: Powertrain

Engine | Transmission | Drive Axle | Chassis | Fuel

  1. ls2 intake on GM900

    Im about to mount my ported ls2 intake manifold on GM900 truck, the questions is, this intake has 1 plastic tube on each side , right behind the...

    Started by gm327‎, 02-14-2010 07:21 PM
    • Replies: 4
    • Views: 951
    02-14-2010, 07:54 PM Go to last post
  2. yellow spring?

    im reading this book and it says the yellow ls6 valve springs are the same part number as ls1, lq4 and lq9 springs

    Started by danger_ranger83‎, 02-11-2010 10:47 PM
    • Replies: 3
    • Views: 901
    02-14-2010, 10:35 AM Go to last post
  3. fuel injector swap question??

    i was wondering before i spent the money, will corvette/camaro ls1/ls6 fuel injectors fit my 2004 avalanche with a 5.3 without new fuel rails or a...

    Started by st8kfinger‎, 02-06-2010 02:04 AM
    • Replies: 4
    • Views: 4,055
    02-13-2010, 11:45 PM Go to last post
  4. Question Stall Converter Installation

    How Hard Is This Guys?rating It 1-10 10 Being Hard...ive Changed Trannys/clutches Etc But Have Never Swapped A Stall Converter.i Know I Can Do...

    Started by CHEVROLADE‎, 02-13-2010 08:07 PM
    • Replies: 5
    • Views: 1,576
    02-13-2010, 11:00 PM Go to last post
  5. Question Another dual exhaust ?

    Okay so I have been reading ever since I have been a member of this here forum and really have picked up some good information. So here is my...

    Started by timber74wolf‎, 02-10-2010 03:56 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 2,016
    02-13-2010, 07:48 PM Go to last post
  6. Easton Posi Installation Instructions

    Bigger pictures: Eaton Posi Install Instructions Eaton Installation OK, I decided to take on the Eaton install recently and, while the Eaton...

    Started by agreif‎, 08-29-2007 08:17 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 13,837
    02-13-2010, 07:42 PM Go to last post
  7. another cam recommendation

    I have a 2007 new body GM crew cab 1500 has the 5.3 ho I am going to order a circle D converter 3000rpm what is the best cam to go with that ? I have...

    Started by 2007L33‎, 02-12-2010 08:34 AM
    • Replies: 4
    • Views: 1,352
    02-13-2010, 06:32 PM Go to last post
  8. Pushrods?

    So I have the z06 cam and I found tsp 7.4 pushrods out of a ls6 will this work in my 4.8?

    Started by 02SS‎, 02-13-2010 06:19 PM
    • Replies: 1
    • Views: 557
    02-13-2010, 06:29 PM Go to last post
  9. Question Anyone know the weight of a stock ls2 piston???

    just like the title says, with or without rod, pin, rings etc...

    Started by 00sierra4x4‎, 02-02-2010 07:51 PM
    • Replies: 1
    • Views: 881
    02-12-2010, 07:51 PM Go to last post
  10. Whats a good 4x4 converter??

    So I'm running 34" tires with factory 4.10's, I only tow a small trailer maybe 3-4 thousand pounds very rarely. What would be the best stall speed...

    Started by Next Level‎, 02-12-2010 04:48 PM
    • Replies: 4
    • Views: 1,188
    02-12-2010, 07:42 PM Go to last post
  11. Do throttle body spacers work?

    I have read different reviews and threads left and right, and no can agree on if tbs work, I have some extra cash from my tax refund and was looking...

    Started by 99silveradodude‎, 02-11-2010 01:50 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 2,499
    02-12-2010, 05:03 PM Go to last post
  12. Exclamation et streets

    wheres a good place to get some et streets or some others street leagal slicks, i went on micky thompson and they dont really have the ones i want...

    Started by michaelweston1@yahoo.com‎, 02-10-2010 01:42 PM
    • Replies: 5
    • Views: 1,033
    02-12-2010, 12:29 PM Go to last post
  13. misfire

    my truck developed a miss fire that comes and goes . i replaced the injectors with another set, no change. then i removed the tr55's and all had soot...

    Started by 1 bad blazer‎, 02-03-2010 09:11 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 1,742
    02-12-2010, 11:40 AM Go to last post
  14. lm4 5.3l

    How much power can these take before they blow. just wondering cause i dont wanna blow it for 3 years until its payed off lol. thanks zach

    Started by zbiddle91‎, 02-09-2010 01:38 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 3,396
    02-12-2010, 11:38 AM Go to last post
  15. Valve to piston clearance?

    Does anybody think I may have any valve to piston clearance issues with this set up on a stock specs bottom end 5.3L? Heads- 5.3L 706 castings,...

    Started by joeoby78‎, 02-10-2010 04:39 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 3,892
    02-11-2010, 10:20 PM Go to last post
  16. who's running snow water meth?

    how reliable has it been? any problems with the system?

    Started by straightaxle‎, 02-10-2010 02:27 PM
    • Replies: 5
    • Views: 952
    02-11-2010, 09:59 PM Go to last post
  17. 5.3 ho valve springs ?

    What springs do the L33 come with ? I have a set of 1.8 rockers but want to be sure the springs are OK to use with them ?

    Started by 2007L33‎, 02-11-2010 08:09 AM
    • Replies: 5
    • Views: 2,623
    02-11-2010, 08:21 PM Go to last post
  18. Transmssion help....

    I have a 2001 Chevy 1500 2wd auto v6. AAMCO did the transmission rebuild a few months ago. It took them 2 try's to get it right and I think I'm still...

    Started by carnell‎, 02-11-2010 12:12 AM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 2,205
    02-11-2010, 08:11 PM Go to last post
  19. 2000 silverado running bad

    My 2000 recently began stumbling off idle up to about 2K rpms. The stumbling varies from almost non-existent to happening every time I take off at a...

    Started by rat454‎, 01-07-2010 02:05 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 4,424
    02-11-2010, 07:00 PM Go to last post
  20. BBK 80MM Throttle body

    There is someone selling one of these on craigslist for a $100, I just thought I would come on here and ask if anyone on here has one and if they...

    Started by Smoky02‎, 02-11-2010 12:16 PM
    • Replies: 3
    • Views: 829
    02-11-2010, 04:21 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts