+ Reply to Thread
Results 1 to 4 of 4

Thread: Fuel pressure surge 5.3 swap

  1. #1
    Join Date
    Dec 2016
    Location
    South Carolina
    Posts
    3

    Question Fuel pressure surge 5.3 swap

    1992 k1500 blazer
    5.3 swap from an 03 Avalanche
    4l60e
    3k stall
    212/218 .600 cam
    Walbro 255

    I did a 5.3 swap in my blazer, from day one it has not ran correctly I canít even drive it because of has such a bad misfire. I have spent the last couple of months troubleshooting and throwing money at it but so far I have no improvement.

    It has a misfire but it isnít throwing any codes, I did drive it once and within an 8th of a mile it threw a P0101 code, i had to clear the code for it to run again.
    I have replaced the fuel pump , filter/reg, vac hoses, intake manifold gasket, MAF (with a used one) , I cleaned the Injectors and throttle body.

    I use torque pro scan app, it shows no codes, no misfires, o2s are switching.

    Here is a video of the fuel pressure https://youtu.be/S-UbH5Ogdq8


    Here is another form thread with more detailed info. https://www.ls2.com/forums/showthrea...e-tech-support


    Does anyone have any idea what the problem could be?

  2. #2
    Join Date
    Mar 2003
    Location
    San Antonio, TX
    Posts
    11,111
    When an aftermarket cam is installed the misfires are disabled.
    That's why no misfires are showing.
    Get them enabled so you can determine which cylinder is causing the issue.

    The p101 code could be a wiring issue, bad maf or tuning.
    Don't throw parts like that until this is done, it'll save money.

  3. #3
    Join Date
    Mar 2003
    Location
    San Antonio, TX
    Posts
    11,111
    When an aftermarket cam is installed the misfires are disabled.
    That's why no misfires are showing.
    Get them enabled so you can determine which cylinder is causing the issue.

    The p101 code could be a wiring issue, bad maf or tuning.
    Don't throw parts like that until this is done, it'll save money.

  4. #4
    Join Date
    Aug 2011
    Location
    New Port Beach, CA.
    Posts
    54
    Did you do the learn procedure on the crank.
    6.0 MAX Blown

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts