Powertrain | Performance | Electrical |
The CKP System Variation Learn procedure concerning the relationship of the Crankshaft Postion Sensor, or CKP, to the crankshaft reluctor was...
The Idle Learn procedure may be required when: 1.) The PCM loses power or ground (battery or PCM disconnected) 2.) Service programming is performed...
Alright, swapped a regular tbi 350 in my truck. Now it won't get spark. I replaced cap, rotor and coil still no spark. I took the distributor...
OK so finally got done my swap, truck doesn't want to run worth a crap with the MAF plugged in. Cuts out and backfires as soon as you start opening...
Ok i want to remove my abs from my 2000 scsb chevy and just run straight brake lines. My question is if i do will it bother anything engine or tranny...
I have a friend that just put a cam in a 6.0 and he is having problems with it starting. Sometimes it starts fine, and other times it wants to...
Will it actually go away if I replace the oil pickup o-ring? Truck has 185000km second owner and I know its not really causing any problems but i...
Looking to replace my upstream O2 sensors in my 01 2500hd 6.0l. Just looking on suggestions for what brand to use? Acdelco/Bosch/Ngk etc. I know some...
Have to do the fuel pump on my pig tomorrow! She died on the way home today. Anyhow tried to get the bed bolts out quickly before dinner while at the...
my truck was originaly a 4.3 and when I bought it the previous owner put a 5.3 in it. It was throwing an engine code and when we hooked the snapon...
just want to know how common is it for are intake manifold gaskets to go out on out trucks. it was throwin po171 and po175 also had a low voltage for...
code: P1441 evap emissions system flow during non-purge . does anyone know what this means
127xxx, runs great. Just got it 3 weeks ago. Took it straight to oriellys and ran codes, co265,po171 po300, po420,po442,po446,po174. I replaced power...
02 ecsb 5.3 h/c 3800 stall burns up my 80 in about 3 weeks rebuilt it n same thing only lasts about 3 weeks done this about 4 or 5 times factory 80...
Well on my way to work today I started hearing a popping sound when I start to take off, up to about 20mph or so. It sounds like a cv shaft to me,...
Well got the p0332 code today, knock sensor.should I replace both while I got the intake off? Do I need new gaskets for the intake or just rtv it?...
So on my way to work I had my A/C on, which I rarely do because I like to have the windows down and listen to the truck. I'm driving normal and all...
Truck threw this code last week before I left for FL: P0496 Definition: Evap flow during a non-purge condition The ECM has detected pressure...
So, for two weeks I've been riding on pads that are gone, I was just scraping that little metal hook.. Went and changed the rear ones first last...
Alright, its been extreme weather down here in LA for the past few weeks.. a nice sunny day comes up and we take the boat out on the lake.. We see...
Alright, so a few weeks ago, it rained really bad.. the truck started stuttering everywhere.. I replaced the MAF because thats the code it threw, and...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules