Powertrain | Performance | Electrical |
The CKP System Variation Learn procedure concerning the relationship of the Crankshaft Postion Sensor, or CKP, to the crankshaft reluctor was...
The Idle Learn procedure may be required when: 1.) The PCM loses power or ground (battery or PCM disconnected) 2.) Service programming is performed...
Hey guys been away a long time. We got finished rebuilding the LQ4 in my son’s ‘99 Silvy 2500. when I say rebuild, it was a FULL rebuild including...
Basically I lost 3rd and reverse so I tore it down and did a complete rebuild. Now I just have no reverse, 3rd works just fine. The weird thing...
My truck has a T as the 8th digit, what does this stand for? What is the difference is this from the U digit or any other for that matter - thanks.
ok boys and girls.. put the TBSS intake and TB on the ole 03 SSS yesterday with Shifty's help. couple of questions.. we're hearing a squeal that...
I installed a Transgo HD2 and Corvette 1-2 servo into my 2003 1500 4l60e. This is my third Transgo HD2 I have installed over the years in various...
I just bought my 99 Silverado Z71 RCLB, 5.3L, automatic. Has 155k on her, and I think she's had a real hard life. I replaced the plugs and wires as...
Have to do the fuel pump on my pig tomorrow! She died on the way home today. Anyhow tried to get the bed bolts out quickly before dinner while at the...
Today im going to be installing the electrical to make my cut out useable, the cut out is from Racereadyperformance.com i was to much of a cheap ass...
i picked up a gas tuner for my 05 silverado but every time i try to load the app into my truck i get a " Error 358, j1850 4x speed frame error,...
just had my 2004 silverado 4.3l swapped out with a 6.0 and all but one cylinder is getting spark. had new heads, intake and cam installed. and...
2003 Chevy Suburban, 2500, 6L: Intermittent IPC Class 2 serial data communication. DTC U1000. I’ve checked the +ve and -ve pin connections on the...
engine light was on ,started noticing my truck when i first get on the gas it backfires through the cold air intake real loud kind of embarrasing...
Ok, I'm still getting a ticking noise even after i changed the lifters. It definitely sounds like valvetrain but I need some opinions. I hope the vid...
only code my truck throws now...po 191-((fuel rail pressure sensor)) what should i check or look for...u know GG?
i'm relatively new to the forum thing and this is my first post on here so sorry for the lack of SOP anyway, i've got a 2000 extended cab...
i pulled the heads off my 6.0 installed cam etc put in new gaskets and re installed the head bolts but was told they were torque to yeild but wasnt...
Well i got in my truck to run to the grocery store and a message come up and said reduced engine power. What does this mean? Also i am having to try...
Truck threw this code last week before I left for FL: P0496 Definition: Evap flow during a non-purge condition The ECM has detected pressure...
Hey guys. Kind of a troubleshooting post, but does involve dod delete and an eaton (tvs) charger. Gotta 2011 truck, 5.3L, 6speed auto. ...
First off my trucks got 150000 miles on it and i just installed a new tsp224r cam, 7.4 pushrods, comp 918 springs, new factory timing chain, and...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules