Engine | Transmission | Chassis | Fuel
Ok after i got my turbos running i had oil blowing out of both inlets so i knew it was rebuild time. I made a few phone calls and every one wanted...
You can thank cjriojas for creating these. Head Flow Chart Intake Flow Chart
so im new to this and trying to build my motor right. i have a 5,3 with 799 heads. im pulling the motor to put in LQ4 block bored 30 over forged...
hey guys, Here's a truck, belonging to a forum member, that has gone through a lot of changes. Originally, the truck started it's life as a...
So as many know ive been planning on tearing down my truck and starting at the frame....again, evrything is getting done, brakes, shocks, drilled...
Hey everyone just wanted to see if I could get the part # for the walbro fuel pump for my 05 with a ls2. Maybe the aeromotive pump also if you...
Figured this would be a good place to start listing and keeping track of what I need/may need to do for the turbo install. If any of you experts...
Haven't been able to find information on weather i can run E85 or not on a 2009 GMC sierra 4.8. In HP tunersit does have a section for flex fuel and...
well i have started mounting stuff for the twin turbo setup i am doing, while i swapped cams last week i went ahead and tapped the timing chain cover...
SICK!! CLAIMS 25+HP OVER FAST INTAKE AND MORE LOW END TORQUE,SOMETHING US TRUCK GUYS NEED-NOT BAD FOR $400.00 TUNNEL RAM DESIGN
Ok, decided to go ahead and turbo the Tahoe. going to start slow, do some preliminary fabbing of the crossover and such and keep it running while...
Was thinking of using a 90mm (actually 88mm) throttle body off a newer 6.0 & 6.2 truck engine with the 4 bolt pattern but my stock intake is for the...
I finally got rid of the Air Ride off the rear and put Ridetech coilovers on it to match the front. I also added a 28 gallon tank to help in between...
Hey fellow chevy enthusists, I am new to this forum. I have a 2006 5.3L Silverado Z-71 4 x 4 crew cab. My warranty recently ran out and I am looking...
So seeing how I was banned off performance trucks forever I will ask you guys I have a bone stock crew cab 1/2 ton 2wd with stock 5.3 and 4l60e I am...
OK here goes.. why not replace the stock 2004 gmc5.3 pump witha E85 pump to get more flow right..afterall E 85 needs more flow for given HP! ...
This is why I sold the STS kit. I think it's gonna make some good power, not that I'm looking to break any records, but I'm sure it'll lay 500hp to...
For the past month I have been building and testing A hydrogen generator. After Lots of ups and downs I have finally finished. I researched different...
The truck cranks (5.3l LM7) have a little bit more of a stroke according to the numbers that i have seen when compared to the LS1 car cranks stroke. ...
I think it will be enough:D :cool: Forced Fed Baby P.S ALLEN, better turn the boost WAYYYYYYYY UP:LOL: JFWY
well i guess more of a comparison than a debate. Here is the comparisons i want to see. 1. Lag 2. power potential at a given rpm 3. efficiency...
OK I have a 2000 Z-71, I put a 5.3 from an 05 avalanche, Heres what iv done so far, 4.10 gears, K&N cold air kit, Flowmaster 40 series single pipe,...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules