+ Post New Thread
Page 98 of 209 FirstFirst ... 48 88 96 97 98 99 100 108 148 198 ... LastLast
Threads 1941 to 1960 of 4169

Forum: LSX Truck Conversions

All LS Based Conversions

  1. Will a 4L80E fit?

    I know the section says LSX Truck but.. I want to put a turbo LSx/4L80e in my 94 mustang. Does anyone know if this trans will fit with out hacking...

    Started by 7two‎, 02-26-2010 04:13 PM
    • Replies: 2
    • Views: 2,926
    02-26-2010, 04:18 PM Go to last post
  2. Need advice on headers and exhaust setup

    Hi, were in the process of building a 408 for my dads 99 silverado, were looking for 1 & 3/4" headers that fit good, we were hoping for longtubes...

    Started by mr2cam‎, 02-25-2010 02:16 PM
    • Replies: 7
    • Views: 2,867
    02-25-2010, 04:05 PM Go to last post
  3. final ?

    Ok I'm finally to the point that if nothing else comes up I hope to put my ls1/700r4 combo back in the truck after being apart since September. The...

    Started by never2low‎, 02-24-2010 05:32 PM
    • Replies: 0
    • Views: 1,423
    02-24-2010, 05:32 PM Go to last post
  4. Exclamation LS1 injectors on L76 rails HELP!!

    I'm finishing up on my 6.0 build with the L76/L92 upper and purchased a set of FAST injectors to go with all of this. Now that i've got them in my...

    Started by h_friesen‎, 02-19-2010 11:36 PM
    • Replies: 2
    • Views: 1,916
    02-23-2010, 10:36 PM Go to last post
  5. tranny?

    i have a 4l60 tranny with a 12 pin connector, i have a 6.0 tht needs a 13 pin. what can i do 2 fix this, dont rly wanna buy a new tranny right now...

    Started by youngbuck‎, 02-20-2010 04:58 PM
    • Replies: 2
    • Views: 1,780
    02-22-2010, 01:58 PM Go to last post
  6. Question cruise control conversion ?

    Need some help. I would like to keep my cruise control thats in the truck. How can I run it through the factory switch on the column or can I? The...

    Started by 85stepside‎, 02-21-2010 01:40 PM
    • Replies: 6
    • Views: 3,281
    02-22-2010, 12:20 PM Go to last post
  7. Well color me ignorant....

    For a long time now, I've been collecting parts for my LSx swap for my S10. I've got the short block ready and am about to drop the heads on. A...

    Started by performinnorman‎, 02-17-2010 11:25 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 6,324
    02-20-2010, 11:29 PM Go to last post
  8. 6.0 swap...

    i have a 1993 z71 with a 5.7 an a 4l60e. will the 6.0 hook up with my tranny or am i screwed, an have 2 get a new tranny?

    Started by youngbuck‎, 02-18-2010 08:19 PM
    • Replies: 4
    • Views: 2,688
    02-19-2010, 11:45 PM Go to last post
  9. What Generation Do i have?

    I have a 5.3L we pulled from a 2001 Sub. I know the throttle body is DBW but i am tring to find out what generation the engine 1 2 ro 3. can anyone...

    Started by 87OldYeller‎, 01-18-2010 12:12 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 5,308
    02-19-2010, 09:45 PM Go to last post
  10. 4.8 or 5.7?

    My truck has a 4.8 in it right now. Cant find any 6.0s around in good shape. have the opportunity to scoop up a ls1 pretty cheap. Good idea or keep...

    Started by Trevor‎, 02-18-2010 11:45 PM
    • Replies: 7
    • Views: 2,904
    02-19-2010, 03:51 PM Go to last post
  11. non emissions long tubes

    hey guys just bought a set of these headers 250572998194 they are alot like the ones you see on ebay but better quality with a warranty. if you call...

    Started by robznob11‎, 02-02-2010 08:06 AM
    • Replies: 9
    • Views: 3,183
    02-19-2010, 03:03 AM Go to last post
  12. engine swap for 91 c1500

    im new to the site and looking for some info on a possible ls swap for my 91 c1500 single cab. I wanted to see if there were already some threads on...

    Started by zingerstruck‎, 02-19-2010 12:38 AM
    • Replies: 1
    • Views: 2,507
    02-19-2010, 12:40 AM Go to last post
  13. 6.0 lq4 with 700r4

    im in the process of swapin a lq4 into my 88 shortbed n since i just built my 700r4 i wanna make the build worth it. wat will it take to make it...

    Started by el guapo2‎, 02-17-2010 01:24 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 9,897
    02-18-2010, 09:02 PM Go to last post
  14. ls1?

    Ok looking to swap motors as about everyone knows. I know a ls1 is obviously lighter then the truck motors. Yet it doesnt have the cubes of a 6.0. If...

    Started by Show&Go‎, 02-16-2010 10:21 AM
    2 Pages
    1 2
    • Replies: 18
    • Views: 5,163
    02-17-2010, 11:27 PM Go to last post
  15. LQ4 intake question

    In the middle of the manifold on top there is a plastic tube with a green cap on front what is that? I'm gonna run mine without emissions and want...

    Started by Pavetim‎, 02-08-2010 08:33 PM
    • Replies: 8
    • Views: 3,340
    02-17-2010, 10:56 PM Go to last post
  16. Will this intake work on my LQ4?

    Just cant seem to find a clear answer! LS1 intake manifold corvette camaro used : eBay Motors (item 110491300823 end time Feb-13-10 19:52:59 PST)

    Started by y5mgisi‎, 02-10-2010 10:30 PM
    • Replies: 9
    • Views: 2,988
    02-17-2010, 10:51 PM Go to last post
  17. Classic turck LS1 Swap

    think this might help anyone, who has looked into a swap. Chevy LS1 Engine Setup - Classic Trucks

    Started by 87OldYeller‎, 02-17-2010 03:07 PM
    • Replies: 0
    • Views: 2,109
    02-17-2010, 03:07 PM Go to last post
  18. tb question

    will a truck tb work on an fbody intake? i have been searching for car intakes on the web and can't seem to find one with a dbc tb on it as well. i'd...

    Started by all22s‎, 02-17-2010 10:25 AM
    • Replies: 1
    • Views: 1,731
    02-17-2010, 10:43 AM Go to last post
  19. do i need to swap ecm and harness on 4.8 to 6.0

    do i need to swap the ecm and harness to go from a 2001 4.8 to lq9? can the computer be reflashed? thanks for any help!

    Started by jpf1981‎, 02-12-2010 10:53 PM
    • Replies: 2
    • Views: 1,917
    02-15-2010, 11:25 PM Go to last post
  20. Unhappy 5.3 swap into 01 gmc sierra

    i got a 01 sierra that has a 5.3 that was dropped in it. i bought the project from a guy who had to deploy. i finished mounting the engine and tranny...

    Started by Edwardd‎, 02-13-2010 06:13 PM
    • Replies: 4
    • Views: 2,012
    02-15-2010, 03:24 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts