Forum: LSX Truck Conversions

Frist let me say this is a very helpful site and to the crew at Nelson's these people are top notch to all you guys thank you the wiring harness and...

I'm putting the original getrag 5-speed behind a '05 4.8L into my '93 Silverado. My bellhousing has the fork and slave cylinder type throw-out...

Im installing a lq4 with the short crankshaft to a 700r4 in a 92 k1500. running into issues with the dust/torque convertor cover. I was wondering...

does any one know what hoses to use? mine are to long so the hoses tend to bend and restrict flow. trying to avoid cutting and making new ones.....

whats all needed to make this work besides changing the reluctor wheel..trying to put a 07+engine in a 2002

hey guys, I have a 70 c10 I just put an lq4 in. it has a cam, long tubes, and typical supporting mods. I'm running an aeromotive fuel pump and bypass...

My nelson harness arrived, I have it all plugged up on the engine and trans. I am going to start wiring it up over the next few days, everything...

Lq4/4l80e swap is 95% done. Its idling high. Not surging or anything just idling high. Any thoughts

1) how are you guys mounting your ls power steering pump lines to the '84 C10 steering box and which side is which again....:lol: 2) I got the...

Ok, I have got my lower V6 mounts out of the way and the correct V8 mounts on the frame, I have a 4L60E from a 03 model mounted up to my 5.3 motor,...

Have a 03 Suburban engine ( 5.3 ) in my 95 GMC Sierra. What upper and lower radiator hoses so I need for this swap?:rolly:

Got the fans but of course they dont fit right. What have yall done to make them fit better?

Ran into a snag on the fuel rail, the single rail will not work with the injectors from a dual rail setup, they are too short, I am going to just go...

Hey guys I recently sold my 08 crew cab to buy a newer one but just found a pretty good deal on a 85 crew cab that has no engine or tranny. I would...

Hey guys im new to this site, im swapping an ls1 and 4l60you out of a 98 z28 into my 89work c1500 i have most of the things figured out except for...

im running my stock compressor from the obs truck (89) model and my stock gauges, i have my harness from nelson but im totally lost on this part of...

I'm putting a 2003 5.3 truck engine in my 1990 xcsb p/u.Will the stock manifolds from the 2003 motor fit with this swap or do I need some other stock...

Does anyone have the sales email for S&P. Their website is the worst made i have ever seen!

I have a 91 GMC RCSB that I just put a 4/6 drop in. It has a 700R4 in it. I want to LS swap the truck. What LS to use? Its a street truck used as a...