All LS Based Conversions
finally im about to start my swap i have all parts ready minus fuel filter and lines. motor just came in today. i also recently found out that my...
So I've searched several times and have yet to find an answer. I just got my '93 to '05 6.0/4L80 swap put back together, but can't get the tach to...
I apologize if this isn't the correct section for this, but there is no area that really has anything to do with brakes. Being that this is a...
Here is my project, its a 90 rcsb. It was dubbed project eyesore by my wife while it sat for a week in the driveway. It was bagged to lay frame on...
I have searched a bunch and can't find out what color wire (s) need to be hooked up from the inst cluster to make the speedo/odometer/trip to work....
Got this truck in late January 2012. Was looking for one for a while, finally found one. Putting in a 03 LM7 from a Suburban. Now the work starts,...
I have a 89 c1500 and am trying to get my speedo and temp sender working. I ordered the 98 camaro 3 wire temp sender and pigtail, so witch wires go...
I am looking for an inexpensive way to route a custom air intake for my set up. 1994 obs with a 5.3 and a truck intake manifold. Have the battery...
After putting 100,000 miles on my '06 Denali, going through 3 front differentials and two transfer cases, I decided it was time to make the...
ok so ive looked and read all over the net and lt1swap, either im not understanding or just totally confused. Im tryin to convert my dbw to dbc....
I am in the process of putting a 80000 mile 5.3 and 4l60e out of a 2wd avalanche in my 41 chevy pickup. I got the harness done now have to get the...
Ok so i ordered these, what else do I need, I've been searching around but I'm getting mixed solutions, can someone help its for an 1989 obs thabks...
Ok I tried ls1swap and was told y'all would better suite my needs. So I got a 91 k2500 with a blown engine and wore out trans. Next to it is a 99 z71...
Hey AC Guru's, I've recently installed my AC with the Kwik Performance setup and have hooked my compressor up through the original AC compressor...
ok guys so i started to cut wire from the passenger side harness that goes to the computer. when i pulled the old motor i forgot to mark and take off...
I just got a 4l80e today the yellow tag says it was made in 98. the guy i got it from said it was in a square body 2000 chevy 3/4ton. My question is,...
I have. A 1994 c1500 w/t that had the old 4.3 in it. I have the 5.3 dropped I with my 4L60 behind it. The guy from LT1 swap.com already did the pcm...
I am fairly new to this forum and see a lot of great info on these ls swaps here. I have an 09 LY6 that I am planning on putting in my 98 z71. I have...
So I have read the great writeup here on the 60/80 swap. Since I'll be dropping in a 408 in place of my 5.3 that's in there now, logic tells me do...
Now that I have the 5.3 running in my truck I want a scan tool that can read misfire data and bidirectional controls if possible. Stuff like crank...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
