Forum: LSX Truck Conversions

84 c10 has 5.3 4l60e swap I'm having a problem where the truck dies as soon I put it in gear

Hey guys am thinking about selling my 07' vmax motor with 3000 miles and a 4l80e trans with 35,000 miles i have everything but the tcm and tac. i...

here is the rendering for the truck i am building for sema 2010. i just got the rendering back a few days before i left for sema 2009. hope you all...

I have a 1994 dually with a TBI 454. The motor is a mess I meas a MESS. I was wondering if I could do a 8.1 in the truck. I know motor install wont...

To the OBS guys out there, did you use your factory 4l60e trans when you converted to the LS motor and a flexplate spacer? I'm swapping a 5.3 into an...

I know the 4l60e will bolt up, but my other question is will the torque converter from the 5.7 bolt to the 6.0? or will i need to buy one for a lsx...

well im sure its somewhere on the site but i tried searching and couldnt find much at all. i have a 04 silverado 1500 with a 4.8. my question is how...

well tonight really sucked i was about to go for a swim and bang my tranny started to make some crazy noise sounded like blowing thu a peice of grass...

:thanks:i have a 77 chevy need some help putting 5.3 with 4l6o 208 t case how do i get a speedo to work

OK so it's not an LT1 but it's an LT1 tranny. So As some of you might remember I became a member of this site a few months ago, and I posted about...

well ive decided im going to sell my 82 trans am to fund putting my 86 car back together! the wife said if you sell it you can buy the ls based motor...

I scored an '05 LH6 from a Trailblazer Denali for my '51 Chevy project. The engine was delivered in good condition. If my research is correct I will...

I bought a typhoon intake recently. I am looking for a few answers. There is a sensor on the back of the factory intake. On top. Where does this go?...

I see this thread is supposed to be for LSX engines but 5.7 is not listed. Ill just ask anyway since i cant find it. I feel like my main problem im...

O.k. guys I’m tiring to decide on what piston go with. I'm rebuilding 2000 c5 ls1. I have set stock 853 heads. I tiring to decide on witch way I want...

Hey guys. Pretty New here. I just purchased a 5.3 with a hacked up harness and 4l60. I will get some pics posted up here pretty soon. I have been...

Hey guys which flexplate do i use to run a th400 to a 5.3. I have a flexplate from a 2001 silverado. i think it is dished. Or do i need a flat...

Hey I have a 2006 GMC 1500 with a 5.3L. I have been looked around on the internet on how to make a little more power and found that I should do an...

Hello folks, I put a new alum/plastic radiator in my 71 chevy c20. the radiator has provisions for the 99 &up recovery tank. I have all the stuff....