All LS Based Conversions
Hey, I'm in the final stages of swapping an LQ4 out of a 2007 Silverado 2500 into my old Jeep YJ. I have an NV4500 in it and so I had the computer...
So i'm putting an LQ9 in a '65 pickup and figured out a different pulley route for those of you who might be interested. You can take the alternator...
when you swapped out your old motor and put in a 6.0,what was your mpg. i have a complete lq4 and i am anticipating the swap. due to the fact that...
ok im about to start building the motor for the truck. i have a 6.0l block out of a 2004 silverado. im trying to build a 10.5 to a 11.5 motor for the...
I've got an 01 RCSB Silverado 4.3/5spd. I've searched a lot on this swap, and I think I have most of it covered, but I'm still not sure what all my...
i want to convert my dbw to dbc, since i dont have an ecm and i have to buy one, how can i tell if its a cable ecm? or does it matter which one i get?
Just found this site and thought I'd post a little project a mate and I are working on. This is what we started with. Imageshack -...
when it comes to splicing in the few truck harness wires to the engine harness wires, do i simply cut the harness wire in half attach the truck wire?...
Been reading here for a little bit and finally decided to register and post. I have a 68' C10 truck with a big block in it currently, however I am...
anyone know where i can get a maf sensor plug for a 2000 5.3 tahoe new used whatever or a gm part # thanks
The Dorman/Russell/Jeg's aluminum fittings that snap on the Vette filter...how do you get them off? They have plastic lock thingy's that release them...
I'm new to this forum and was wondering maybe if I could get a couple questions answered. I'm swapping out all my stock drivetrain and installing an...
First time poster here. I'm an old drag racer and longtime hotrodder and I'm looking toward my first time LS swap. I would LOVE some opinions on my...
looking for a ls1,ls2,lq9 complete engine i have a big matco tool box and a yamaha dirt bike to trade let me know what ya got .
I am in the process of swapping my tired old 350 and 700R4 for a LQ4 and T56 in my 1991 Chevy C1500 reg cab step side bed pickup. I am using a set of...
Got everything finished up and ready to go get exhaust but I cannot seem to get the air out of the system, the upper hose is getting hot but the...
I'm pulling my stock harness to send to Lextech w/LQ9 harness and I'm stuck on the bulkhead connector on the passenger side. It has two tabs on the...
Hi, I've got a complete 5.3 Gen IV motor and 4l60e transmission with low miles from a 2008 Tahoe that I am considering installing in my 1988 k5...
I'm putting an '05 LQ9 into my '98 Chevy ECSB and was wondering if I should try and use the a/c compressor that's on the 6.0 or if I should get an...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules