Has anyone removed their body moldings on any 02 or 03? I have been considering it but I am not sure if it will look good and what will be needed to do it right without messing up my truck. I would really like some pictures of what on 03ECSB looks like with out them before I start. And could someone tell me what works the best to remove and clean up the adhesive? Thanks
2003 LT, 5.3L Silverado Z71 Dark Grey Metalic
AEM Brute Force intake
Cat back Flowmaster 40 serries 3" duals
Bosch Platinum +4 plugs
let your truck sit out in the sun for a couple hours and it should come all off with the adhesive with it. either that or take a heat gun to it. there might be some left but just peel it off by hand. I personally dotn like moldings on chevy trucks. I like the gmc molding alot though.
old set up: 2002 chevy 5.3, procharger 12lbs boost, asm headers, ls1 edit, flames, 20inch budniks
New Set up: 2004 chevy 5.3 ext cab, 12 inch twisted suspension lift, 36's, exhaust.
future mods: 150-200 shot, ls1 edit, air intake, stall, 5.13 gears, 12s or bust
hey just pull the moldings off and them wipe them with (goo be gone) u can get it at lowes or any hardware store
98 Z28 "Golden Nugget"-SOLD
02 Silvy "Little 4.8"
Right on thanks for the pic BBLS1. When you pull them off does it run the moldings? I think the truck will look alot cleaner but just in case I don't like it I would like to save them so I can trow them back on. I don't know why but i get a littel paranoid when it comes to making a decision like this.
2003 LT, 5.3L Silverado Z71 Dark Grey Metalic
AEM Brute Force intake
Cat back Flowmaster 40 serries 3" duals
Bosch Platinum +4 plugs
Posting Permissions
Reply With Quote